3D Printing & Modeling + Ed3DP

1. Educator 3DP Manual

1.5. Network & PC Interfacing

Network Setup:

The Educator 3DP can be controlled and connected to your Network via the RJ45 ethernet port at the rear and will need to setup as follows:

  1. Web app needs to go onto the SD of the Smoothie control board in the rear of the printer as per these instructions.
  2. Setup up and config for your network



PC Setup:

Educator 3DP can also be controlled via "host" software on a computer via a USB cable to the back of the printer (not the touch screen).  Pronterface is the most common "host" and full instructions are here.  Other software options are here.