Laser CNC Engraving and Cutting + EdLaser

1. Ed Laser Overview

1.1. Firmware & Config

Ed Laser has a Smoothieware control board and the firmware and config files are located on the mini-SD card on the smoothie board itself (not the SD card on the LCD screen).  To access these files you can either plug in a USB to the smoothie board and it will show up as a Drive letter or remove the micro-SD card and access it via your PC etc then put it back (make sure the Ed Laser if off and that no USB cable is plugged in because the SD card will be corrupted if it is removed while powered.

Ed Laser comes preconfigured but if you need to reset then copy the following to the SD card of the Smoothieboard:

Firmware for Ed Laser

Configuration file for Ed Laser